10.3 General Specifications

See

Section 2.2

for power/current specifications, and Section 2.4.1

for dimension/weight specifications.

10.4 Unit Installation

Fabrication of a wiring harness is required. Sound mechanical and electrical methods and practices are

recommended for installation of the GEA 24. Refer to Section 2.3

for wiring considerations, and to Section

26.5

for pinouts.

The GEA 24 connects to other LRUs in the G3X system using the CAN bus. To provide an optional redundant path for engine data, a secondary RS-232 connection to a single GDU display is also supported.

See

Figure 27-1.11

for wiring and configuration information.

1. Mount the unit to a suitable mounting location using (4) #10-32 pan or hex head screws.

2. Assemble the connector backshells and wiring harness.

3. Connect CAN terminator to unit if required (

Section 2.3.1.3.3

).

4. Connect backshell connectors.

10.5 Mounting Requirements

The GEA 24 will mount remotely. The GEA 24 will be secured to the airframe using four #10-32 pan or hex head screws supplied by the installer.

CAUTION

Do not mount the GEA 24 on the ‘hot’ side (engine side) of the firewall, or in any location where it would be exposed to radiated heat from the engine.

190-01115-01

Rev. AN

G3X/G3X Touch Installation Manual - GEA 24 Installation

Page 10-3

10.6 Outline and Installation Drawings

190-01115-01

Rev. AN

Figure 10-2 GEA 24 Outline Drawing

G3X/G3X Touch Installation Manual - GEA 24 Installation

Page 10-4

190-01115-01

Rev. AN

Figure 10-3 GEA 24 Assembly Drawing (no CAN terminator)

G3X/G3X Touch Installation Manual - GEA 24 Installation

Page 10-5

190-01115-01

Rev. AN

Figure 10-4 GEA 24 Assembly Drawing (with CAN terminator)

G3X/G3X Touch Installation Manual - GEA 24 Installation

Page 10-6

11 GI 260 (AOA INDICATOR) INSTALLATION

This section contains general information as well as installation information for the GI 260. Use this section to mount the GI 260 unit.

Figure 11-1 GI 260 Unit View

11.1 Equipment Description

The GI 260 is a remote mount Angle of Attack (AOA) indication. The GI 260 has a pigtail harness for network communication and power connections.

11.2 Equipment Available

11.2.1 Required Equipment

Model

GI 260

Table 11-1 GI 260 Part Numbers

Assembly Part

Number

010-01287-00

Unit Only Part

Number

011-03458-00

11.2.2 Additional Equipment Required

The GI 260 Socket Mount (011-03562-00) is included with the unit. The Socket Mount is secured using (3)

#6-32 100º flat head screws that are to be supplied by the installer.

190-01115-01

Rev. AN

G3X/G3X Touch Installation Manual - GI 260 Installation

Page 11-1