22.3 General Specifications. Garmin G3X Touch for Experimental Aircraft, GDU 465, GDU 455, G3X, GDU 460, GDU 450

25.5 Configuration Module Installation into a Backshell

Table 25-6 & Table 25-7 list parts needed to install a Jackscrew Configuration Module with pins or with

sockets. Parts for these installations are included in the 011-00979-20 and 011-00979-22 kits, which are included in the G3X w/GSU 73 Installation Kit (K10-00017-00).

Configuration modules are to be installed in the backshells of the P732 connector for the GSU 73 (use

011-00979-20 in Table 25-6), the P3701 connector for GDU 37X designated as PFD1 (use 011-00979-22 in Table 25-7), or the P4X02 connector for the GDU 4XX designated as PFD1 (use 010-12553-00 in

Table 25-8)

Item numbers in Table 25-6, Table 25-7, and Table 25-8 correspond to

Figure 25-12

and

Figure 25-13 .

Item #

1

3

4

10

Table 25-6 GPN: 011-00979-20 – Kit (w/EEPROM and pins)

Description

Potted Module (w/EEPROM and

Temp.sensor)

4 cond. Cable harness

Pins Size 22D

Pan head screw

Qty. Needed

1

1

4

1

GPN or MIL spec

011-02179-00

325-00122-00

336-00021-00

211-60232-07

Item #

1

3

9

10

Table 25-7 GPN: 011-00979-22 – Kit (w/EEPROM and sockets)

Description

Potted Module (w/EEPROM and

Temp.sensor)

4 cond. Cable harness

Socket, Size 20, 26-30 AWG

Pan head screw

Qty. Needed

1

1

4

1

GPN or MIL spec

011-02179-00

325-00122-00

336-00022-01

211-60232-07

Table 25-8 GPN: 010-12253-00 – Config Module (w/EEPROM, Temp, & Connext)

Item #

1

3

9

10

Description

Config Module (w/Sockets,

Jackscrew, Temp, Connext)

4 cond. Cable harness

Socket, Size 20, 26-30 AWG

Pan head screw

Qty. Needed

1

1

5

1

GPN or MIL spec

011-03702-00

325-00122-00

336-00022-01

211-60232-07

190-01115-01

Rev. AN

G3X/G3X Touch Installation Manual - Connector Installation Instructions

Page 25-18