Section 23 GPS/XM Antenna Installation. Garmin G3X Touch for Experimental Aircraft, GDU 465, GDU 455, G3X, GDU 460, GDU 450

NOTE

For the following steps please refer to Figure 25-12 & Figure 25-13 .

1. Strip back approximately 0.17 inches of insulation from each wire of the four conductor wire

harness (item 3, Figure 25-12) and crimp either a pin (item 4, Figure 25-12) or a socket (item 9,

Figure 25-12) to each conductor. It is the responsibility of the installer to determine the proper

length of insulation to be removed. Wire must be visible in the inspection hole after crimping and

the insulation must be 1/64 – 1/32 inches from the end of the contact as shown in Figure 25-12.

4 or 9

1

Figure 25-12 Insulation/Contact Clearance

NOTE

Refer to

Figure 25-13 for all item numbers in the following steps 2-6.

2. Insert newly crimped pins (or sockets) and wires (items 3 and 4) into the appropriate connector housing (item 5) location as specified by the installation specific wiring diagram.

3. Attach the module (item 1) to backshell (item 6) using screw (item 10).

4. Plug the four conductor wire harness (item 3) into the connector on the module (item 1).

5. Orient the connector housing (item 5) so that the inserted four conductor wire harness (item 3) is on the same side of the backshell (item 6) as the module (item 1).

6. Attach cover (item 7) to backshell (item 6) using screws (item 8).

190-01115-01

Rev. AN

G3X/G3X Touch Installation Manual - Connector Installation Instructions

Page 25-19