Multi-Channel Television Sound System (VRX462 only). Philips VRX442, VRX462, VCR 462

50 Multi-Channel Television Sound System (VRX462 only) (cont’d)

To receive and record programs broadcast in second audio, follow steps 1 - 10. To record a program broadcast in stereo, make one of the connections shown, then follow steps 1 - 10.

CABLE

BOX

AUDIO

VIDEO

CH3 CH4

R

L

ANT.IN

RF OUT

CABLE

BOX

AUDIO

VIDEO

CH3 CH4

If you have a Stereo and a Monitor TV, use a video cable to connect the VCR’s

VIDEO OUT Jack to the TV’s VIDEO

IN Jack. Use audio cables to connect the VCR’s AUDIO OUT Jacks to the

Stereo’s AUDIO IN Jacks.

1

Press the VCR button, then press the MENU button.

2

Press the Number 4 button to select INPUT SELECT.

3

Press the Number 1 button so that (ON) appears beside

TUNER.

4

Press the EXIT/STATUS button.

5

Press the MENU button.

6

Press the Number 3 button to select TUNER SET UP.

7

Press the Number 6 button to select TV STEREO or the

Number 7 button to select SECOND AUDIO. (ON) will appear beside your selection. You can not record a program in both stereo and second audio at the same time.

8

Press the EXIT/STATUS button to exit.

9

Use the CHANNEL Up/Down buttons to select a channel to record.

10

Press the REC(ord)/OTR button to start recording.

R

L

ANT.IN

RF OUT

OR, if you have a single-speaker

TV, connect the VCR to the TV by following the steps on pages six

- nine. (Use an RF coaxial cable to connect the VCR’s RF OUT Jack to the TV’s ANTENNA IN Jack.)

Helpful Hints

• If you want to connect the VCR to a

Stereo TV, follow these steps.

1) Connect the antenna or cable signal to the VCR’s ANT(enna) IN

Jack.

2) Use stereo audio cables to connect the VCR’s AUDIO OUT Jacks to the TV’s AUDIO IN Jacks.

3) Use a video cable to connect the

VCR’s VIDEO OUT Jack to the TV’s

VIDEO IN Jack.

• Make sure the TV and the Stereo (if applicable) are in Line Input or

Auxiliary mode. Please refer to your

TV or Stereo owner’s manual for details.