Go-To Feature. Philips VRX442, VRX462, VCR 462

Go-To Feature 53

Follow the steps below to program the VCR to go to a place on a tape with a specified tape counter location number.

• Make sure the VCR is in VCR position. (The VCR light will appear on the display panel. If it does not, press the VCR/TV button once.)

1

Press the VCR button.

2

When tape playback is stopped, press the GO-TO button to bring up the GOTO display.

NOW

GOTO

1: 00 : 00

–: – – : – –

1

CBL/DSS VCR TV

EJECT POWER MUTE

VOL

F.ADV

CHANNEL

REW

PAUSE/STILL

PLAY

FF

3

Within 10 seconds, use the Number buttons to enter the

desired tape counter location number. For example, to go to tape counter location number 1:20:00, press Number buttons

1, 20, 00.

NOTE: If the desired tape counter location number has a minus (–) before it, enter the minus by pressing the CHANNEL Down button.

Press the CHANNEL Up button to remove the minus.

NOW

GOTO

1: 00 : 00

1: 20 : 00

4

VCR PLUS+

/ENTER

STOP

EXIT/STATUS MENU

LIGHT

CLEAR

1

4

7

2

5

8

3

6

9

100 0

GO-TO

REC /OTR INDEX

...

MEMORY

VAR. SLOW

TRACKING SKIP

SPEED VCR/TV SLOW SEARCH

3

2

4

Within 10 seconds, press the PLAY, STOP, POWER, or

REC(ord)/OTR button. The VCR will fast forward or rewind the tape to the selected tape counter location. The tape counter will appear on-screen as the VCR rewinds or fast forwards the tape. Then, depending on which button you pressed, the VCR will either begin tape playback, stop the tape, turn itself off, or start recording the current channel.

Button pressed

PLAY

STOP

POWER

REC(ord)/OTR

VCR action

Begin tape playback

Stop the tape

Turn off VCR

Begin recording current channel

REMOTE LOCATOR

Helpful Hints

• To remove the GOTO display, press the GO-TO button again.

• The tape counter location number you enter at step 3 must be valid.

• To stop the tape during rewinding or fast forwarding (before the tape reaches the requested tape counter location number), press the STOP button.