OFFSET. Busch-Jaeger 1098 U-101, 1098 UF-101

8.6.4 OFFSET

Operation

Fig. 15: Menu item OFFSET

If the room temperature set on the device and the temperature measured on-site do not correspond, the temperature can be adjusted via the OFFSET value (correcting value) by up to

±5°C.

Button Display Entry / Comments

Starting times

Special functions

OFFSET

0.0°

0.8°

– Press the menu button for 2 seconds to switch to the setting mode.

– Select menu "Special functions" via the arrow buttons.

– Press the OK button to select menu item

"OFFSET".

The preset value flashes.

Adjust the temperature:

– Set the temperature variance to the measured temperature on-site via the arrow buttons.

– The value can be set in steps of 0.1°C.

– Confirm your entry with the "OK" button.

In this example an OFFSET value of 0.8°C has been entered.

– Press the menu button to switch to menu level

"Special functions".

Special functions

– Press the menu button again to switch to the operating mode.

Table 5: Sequence of operating steps

Product manual 2CKA001473B8291

│

33