advertisement
3
How to use Placing / Answering a Call
Use an external device to place a call
Use an external device (sensor, call button, etc.) to place a call to a pre-determined location.
Input Outgoing
Station
Call button, etc.
1.
Activate the external device
• The ringback tone will play from the speaker of the station.
3.
To end the communication, hang up the handset or tap .
If the call button is connected
2.
Speak when the other party answers
• Lift the handset to switch to handset communication.
• For how to view the screen during a call, refer to
operations during a call.
Note
• It may not be possible to place a call. It depends on the configuration of the station.
• The call is placed using the priority that was set during programming.
• The ringback tone may not be played, depending on the settings.
• If the communication time set in advance is exceeded on your station, communication automatically ends. A notification tone sounds approximately 10 seconds before ending. The notification tone may not sound depending on the configuration.
• If a page with a higher priority is received from another station while making an outgoing call or during a communication, the outgoing call or call will be interrupted and the station will switch to the page.
• Topping during communication turns off the microphones of the handset and the station as well as camera video. Tap to turn them back on.
• When receiving another call while talking, a notification tone will be heard from the handset or built-in speaker. Tap
to choose the station to communicate with.
36
advertisement
Related manuals
advertisement