Software and documention. Beijer Electronics X2 control

X2 control – Basic Start Up settings

SUEN284 2017-04

4 Software and documention

Use the following software and drivers in order to obtain a stable configuration and application.

It´s always recommended to check the website for latest information, software and documentations: http://www.beijerelectronics.se/sv-SE/Products/Control___systems

Software programs

 iX Developer 2.20 SP2 or later.



CODESYS 3.5 SP10 Patch 1 or later



CODESYS Runtime (compiler) 3.5.10.10 or later

X2 control, Software Firmware (Image)



Version 1.2 Build508? or later.

(X2ImageLoader_build508.exe)

Driver, iX Developer <-> CODESYS



SoftControl Direct Access version 4.03.03 or later.

X2 control, Device description file



X2 control.xml

, to enable iX X2 control device in CODESYS.

Communication to Remote I/O



StartUp document:



KI00376 EtherCAT (NA-9286)



KI00377 ModbusTCP (NA-9189/NA-9289)



KI00378 Modbus RTU (NA-9173/NA-9473)

In this document we have used following software

 iX Developer 2.20 SP2



CODESYS 3.5 SP10 Patch 1



CODESYS Runtime (compiler) version 3.5.10.10

In this document we have used following devices



X2 control 10



Remote I/O, Crevis FnIO-S series

For further information we refer to

 iX Developer Reference Manual (MAxx831)

 iX Developer User's Guide (MAxx832D)



SoftControl Direct Access, driver help in iX Developer



X2 Image Software, reference manual (MA205A)



CoDeSys manuals and help in the software: https://www.codesys.com/

This document and other Start Up documents can be obtained from the website. www.beijerelectronics.se

3 (19)