Communication - iX Developer and CODESYS with Remote I/O. Beijer Electronics X2 control

X2 control – Basic Start Up settings

SUEN284 2017-04

9 Communication - iX Developer and CODESYS with Remote I/O

The X2 control device uses two drivers for communication between HMI-application, PLCapplicatio and Remote I/O.

Driver 1:

- HMI application with X2 control and SoftControl Direct Access driver

Driver 2:

X2 control with Remote I/O via:

- EtherCAT

Recommend Ethernet port marked LAN A

- Modbus TCP

Recommend Ethernet port marked LAN B EtherCAT defind.

- Serial Modbus RTU

Serial port marked COM1 : RS232, COM2 : RS422/RS485, COM3 : RS485

X2 control iX

HMIapplication

Driver 1 CODESYS

PLCapplication

Driver 2

Example:

Crevis FnIO-S Series www.beijerelectronics.se

10 (19)