Connecting Your TV (video connection). ONKYO CD-S501S, LS-V501 (DR-S501), DR-S501

24

Connecting the DVD receiver —Continued

Connecting Your TV

(video connection)

• Connect the DVD receiver directly to your TV. If you connect the DVD receiver through a VCR, TV/VCR combination, or video selector, the picture may be distorted because DVD-Video discs are usually copy protected.

Using Component Video

You can use the component video output instead of the standard video out jack to connect this receiver to your

TV (or other equipment).

This will provide better quality picture than composite video.

This jack cannot output the signal from composite video input.

• Use a component video cable (not supplied) to connect the COMPONENT VIDEO OUTPUT jacks to a component video input on your TV (or monitor).

If you connect the component video output to a TV or another component that doesn’t support progressive scanning, be sure to turn off HDMI (see page 30).

You can set the component video output to Progressive or Interlaced (see page 30).

Using SCART (European model only)

If your TV has a SCART-type AV input, you can use a

SCART cable to connect this receiver to your TV. This type of connection carries both the sound and the picture.

• Use a SCART cable (not supplied) to connect the AV

CONNECTOR to an AV input on your TV.

TV

SCART

This connector can output composite video, or RGB video. The default setting is composite, which should work with all TVs. Consult the manual that came with your TV to see if you can use one of the higher quality settings. See page 62 for how to change the video output.

TV

Y P B P R

COMPONENT

VIDEO IN

Compatibility of this unit with progressive-scan TVs.

This receiver is compatible with progressive video

Macro Vision System Copy Guard.

CONSUMERS SHOULD NOTE THAT NOT ALL

HIGH DEFINITION TELEVISION SETS ARE

FULLY COMPATIBLE WITH THIS PRODUCT

AND MAY CAUSE ARTIFACTS TO BE DIS-

PLAYED IN THE PICTURE. IN CASE OF 525 OR

625 PROGRESSIVE SCAN PICTURE PROBLEMS,

IT IS RECOMMENDED THAT THE USER

SWITCH THE CONNECTION TO THE “STAN-

DARD DEFINITION” OUTPUT. IF THERE ARE

QUESTIONS REGARDING OUR TV SET COM-

PATIBILITY WITH THIS MODEL 525p AND 625p

DVD RECEIVER, PLEASE CONTACT OUR CUS-

TOMER SERVICE CENTER.