Connection with External Devices. ONKYO CD-S501S, LS-V501 (DR-S501), DR-S501

74

Troubleshooting —Continued

No sound, or sound is distorted

• No sound is output when scanning discs other than audio CDs and SACDs.

• Check that the disc is free from dust and dirt, and that it is not damaged (page 10).

• Check that the plugs and terminals are free of dirt, oxide, etc. and clean if necessary. Also check the cable for damage.

Noticeable difference in DVD and CD volume

• This is due to differences in the audio format and is not a malfunction.

DVD-Audio playback stops

• The disc may have been illegally copied.

Can’t watch the DVD-Video

• With some DVD-Video Discs, you need to select an audio output format from a menu.

Can’t watch the DVD-Video material on a DVD-Audio disc

• Set the “DVD Priority Contents” setting to

“DVD-VIDEO” (page 67).

Can’t play the multichannel area of a hybrid SACD

• Set the “SACD Priority Contents” setting to “Multi ch

Area” (page 67).

Can’t play MP3 and JPEG discs

• Use only ISO 9660 Level 2 format discs (page 9).

• The disc has not been finalized. Finalize the disc

(page 9).

Can’t select MP3 files

• MP3 files without a “.mp3” or “.MP3” filename extension are not recognized.

• The MP3 disc is a multisession disc. Only files in the first session of a multisession disc can be played

(page 9).

Can’t play WMA files

• WMA files without a “.wma” or “.WMA” filename extension are not recognized.

• The WMA file’s copyright option is on. Don’t use the copyright option (page 9).

Can’t view JPEG files

• JPEG files without a “.jpg” or “.JPG” or “.JPEG” filename extension are not recognized.

• The JPEG file is too big. Use JPEG files that are less than 5 megabytes (page 9).

Can’t play a DivX file

• Make sure the DivX file was encoded with the predetermined format (page 9).

DivX plays but there’s no sound

• Try re-encoding the file with a supported audio format.

Connection with External Devices

No sound is heard from the connected device

• Make sure that the optical digital cable is not bent over or damaged.

• Set the “Digital/HDMI Audio Out” to “PCM”, because the TV supports only PCM signals.

The turntable sounds still

• Make sure if the turntable has built in phono equalizer.

• If the turntable has no phono equalizer built in, you must provide one separately.

The turntable makes no sound

• If your turntable uses an MC cartridge, you must connect an MC transformer or an MC head amp.

The Colors of the TV Picture Bleed

• Locate the speakers far from the TV.

Others

The display doesn’t work

• The display is turned off when the Pure Audio listening mode is selected (page 42).

The DVD receiver contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.

Before disconnecting the power cord from the wall outlet, set the DVD receiver to Standby.