on the DVD receiver. ONKYO CD-S501S, LS-V501 (DR-S501), DR-S501

28

Connecting the Power/Turning on the DVD receiver

Before connecting

• Make sure that all the connections on pages 17–27 are complete (the connection to a TV is required).

STANDBY/ON

STANDBY indicator

• Before unplugging the receiver from the power outlet, make sure you first switch it into standby.

• For the above reasons, do not plug this receiver into a switched power supply found on some amplifiers and AV receivers.

1

STANDBY/ON

Plug the supplied power cord into the AC INLET and then into the power outlet on the wall.

• Do not use a power cord other than the one supplied with the DVD receiver.

The power cord supplied is designed for use with the DVD receiver and should not be used with any other device.

• Never have the power cord disconnected from the DVD receiver while the other end is plugged into the wall outlet. Doing so may cause an electric shock. Always connect by plugging into the wall outlet last and disconnect by unplugging from the wall outlet first.

To a wall outlet

2

DVD receiver

Remote controller

Press [STANDBY/ON] button on the DVD receiver or the remote controller.

Turn on your TV and select the input through which the DVD receiver is connected.

The DVD receiver turns on and the

STANDBY indicator turns off.

• To put the DVD receiver in the standby mode, press [STANDBY/ON] on the

DVD receiver, or [STANDBY/ON] on the remote controller.

• While the STANDBY indicator lights up, the DVD receiver can receive signals from the remote controller.

• Setting the [STANDBY/ON] button to standby does not shut off the power completely.

Note:

DVD receiver features a screen saver and an auto power off function. If the receiver is stopped and no button is pressed for 15 minutes, the screen saver starts (see page 65).