AUTOMATIC CHANNEL SET UP. Sylvania SSD800

H9229UD.qxp 02.7.31 2:24 PM Page 17

SETUP

AUTOMATIC CHANNEL SET UP

VCR

The VCR can automatically program the tuner to scan only the channels which are available in your area.

¡

Channel memory programming is NOT needed when the VCR is connected to a cable box or a satellite box as in "DVD/VCR TO TV CONNECTION" on page 14. In this case, set the CH3/CH4 Switch

(which is located on the back of your VCR) to either

CH3 or CH4, whichever is not used for normal broadcasts in your area. Then set your TV to the same channel. The channel you want to record or view will be selected from the cable or the satellite box.

¡ Follow the steps below once. Repeat only if there is a power failure or if the VCR is unplugged for more than 30 seconds. (In these cases, the programmed channels are erased.)

¡ You must follow the steps below before attempting to play or record a video tape.

5

Begin channel preset by pressing the F.FWD

button once. The tuner scans and memorizes all active channels in your area.

¡ The VCR distinguishes between standard TV channels and cable channels.

CH 01

AUTO SET UP

6

After scanning, the tuner stops on the lowest memorized channel. The TV screen returns to

TV mode.

¡

If “AUTO SET UP” appears on the TV screen again, check the cable connections. Press the F.FWD button once again and the VCR will begin preset again.

1

You need to connect the antenna or cable to the VCR first. Then, connect the DVD /VCR power plug to a standard AC outlet.

2

Turn on the TV and set the TV to channel 3 or

4.

¡ Now set the CH3/CH4 switch on the back of the

VCR to match the channel selected on the TV.

TO SELECT A DESIRED CHANNEL

You can select the desired channel by using the

CHANNEL buttons (o/p) or by directly pressing the

Number buttons on the remote control.

Note for using the Number buttons:

¡ When selecting cable channels which are higher than

99, press the +100 button first, then press the last two digits.

¡

You must precede single-digit channel numbers with a zero (For example: 02, 03, 04 and so on).

TO PRESET THE CHANNELS AGAIN

3

Turn on the VCR by pressing the POWER button. Both the POWER and the VCR/TV light will come on.

1

Press the MENU button until the main menu appears. (If you have already set the clock, you only have to press it once. If not, you have to press it twice).

4

Select the On Screen Language (“ENGLISH”,

“FRANCAIS” or “ESPAÑOL”) by pressing the

PLAY or the STOP button.

Then, press the F.FWD button.

2

Select “CHANNEL SET UP” by pressing the

PLAY or the STOP button. Then, press the

F.FWD button.

3

Select “AUTO SET UP” by pressing the PLAY or the STOP button. Then, press the F.FWD

button.

¡

After scanning, the tuner stops on the lowest memorized channel.

– 17 –

EN

1L25