Disassembly. ProTeam 107251, 107252

Motor Housing

DISASSEMBLY

1.

Remove handle and power cord. Open bag housing cover. Remove Intercept Micro® Filter.

2.

Remove switch cover screw.

11

3.

Remove switch cover and filter lockout switch.

To remove the switch cover, insert a flathead screwdriver under switch lever and gently pry upward.

4.

Remove crimps by pressing locking tab on connector.

(Continued on page 12)

www.pro-team.com 866.888.2168

DISASSEMBLY

(CONTINUED FROM PAGE 11)

Motor Housing

5.

Remove (4) bag housing screws and bag housing.

6.

Remove the bag full indicator tube (tube not pictured) from the bulkhead and lift off the bulkhead.

7.

Remove upper motor mount. Lift motor from housing.

www.pro-team.com 866.888.2168

8.

Disconnect motor crimps from motor and from lower air duct. Remove motor.

(Continued on page 13)

12

Motor Housing

DISASSEMBLY

(CONTINUED FROM PAGE 12)

9.

Remove (2) lower air duct screws from inside motor housing then remove the foam that covers wire harness.

10.

Housing should look like this after the foam and air duct are removed.

11.

Turn vacuum over and remove (8) screws.

13

12.

Slide duct flex hose from powerhead.

(Continued on page 14)

www.pro-team.com 866.888.2168

DISASSEMBLY

(CONTINUED FROM PAGE 13)

Motor Housing

13.

Remove (2) wheel clamp screws on left and right wheels.

14.

Remove wheels and pivot bearings.

Pull wire harness through body housing.

To Reassemble. Repeat steps in reverse.

15.

Remove exhaust filter.

www.pro-team.com 866.888.2168 14