Detent Spring Replacement. ProTeam 107251, 107252

Power Nozzle

DETENT SPRING REPLACEMENT

1.

Place vacuum on flat surface in unlocked position exposing detent springs.

2.

Use needle nose pliers to remove detent spring if there is adequate spring to grab.

3.

If there is not enough detent spring to remove with pliers use a flat head screwdriver to pry out broken spring.

4.

Place new detent spring into spring slot in vacuum power head as shown.

5.

Push down on detent spring until fully seated.

www.pro-team.com 866.888.2168 30