Assembly. ProTeam 107251, 107252

Power Nozzle

ASSEMBLY

1.

Insert braces.

2.

Install motor, brush roll, and belt. Be careful. Do not attempt to over-tighten screws.

d b a

Fully assembled power nozzle (bottom view).

3.

Additional components: a) Install sleeve and hose.

b) Install duct cover.

c) Install electronic components, Vacuum Operation Indicator Board, circuit breaker, and power nozzle lockout switch (lockout switch XP models only – not pictured).

d) Attach jumper wire to Vacuum Operation Indicator Board.

e) Make sure components are properly seated in the base.

www.pro-team.com 866.888.2168 26