advertisement
▼
Scroll to page 2
of
44
![Impact Bumper Installation. ProTeam 107251, 107252 | Manualzz Impact Bumper Installation. ProTeam 107251, 107252 | Manualzz](http://s1.manualzz.com/store/data/006276666_1-c764b108adce7026fcadbd709da21ee7-360x466.png)
Handle
IMPACT BUMPER INSTALLATION
1.
Using a Phillips Head screwdriver, remove screw from cord wrap bracket. Discard screw only.
Old Washer
2.
Place new washer on new screw and insert into impact bumper. Place old washer on end of screw.
Note: Make sure spring is installed as shown above.
39
3.
Insert impact bumper assembly into cord wrap bracket.
Note: Screw should be inserted inside spring from
original assembly. Do not over tighten.
www.pro-team.com 866.888.2168
advertisement
Related manuals
advertisement
Table of contents
- 3 Index
- 4 Disassembly
- 5 Index
- 6 Disassembly
- 7 Bag Lockout Switch Replacement
- 8 Hose Cap Collar Repair
- 9 Quick Release Clip Replacement
- 10 Bag Housing to Motor Housing Assembly
- 11 Index
- 12 Disassembly
- 16 Wand Guide
- 17 Wire Harness Replacement
- 25 Carbon Brushes
- 26 Index
- 27 Assembly
- 28 Power Nozzle to Body Assembly
- 29 Hose Sleeve Replacement
- 30 Pivot Bearing Replacement/Wheel Replacement
- 31 Detent Spring Replacement
- 32 Index
- 34 Assembly
- 37 Handle/New Power Cord & Strain Relief Replacement
- 39 Handle and Power Cord Installation
- 40 Impact Bumper Installation
- 41 Assembly
- 42 Clearing Hose and Wand Obstructions
- 40 www.pro-team.com