Assembly. ProTeam 107251, 107252

Handle

HANDLE ASSEMBLY

fig. 1 fig. 2

1.

Use a flathead screwdriver (fig. 1) to pry bottom of switch from the handle body. Disconnect all wires from switch posts by depressing locking tab on base of crimps. (fig. 2) fig. 3 fig. 4

33

2.

Remove screw at base of handle and remove from handle tube (fig. 3).

3.

Feed handle wire harness through new handle and replace screw at the base of the handle (fig. 4).

(Continued on page 34)

www.pro-team.com 866.888.2168

Handle

HANDLE ASSEMBLY

(CONTINUED FROM PAGE 33)

4.

Feed wires through opening on handle bezel.

front of switch back of switch

I

0

II short blue long brown long blue red short brown position II must be on the bottom before attaching wires to spades

5.

Using the diagram provided above, attach wires to switch. Orient the switch box with the II position on the down side.

a) Attach the first plug on the brown wire to the middle left spade.

b) Attach the first plug on the blue wire to the lowest left spade. Wait to attach the last blue plug.

c) Wrap the second brown plug underneath blue and attach to the middle right spade.

d) Attach the last blue plug to the upper right spade. The bottom right spade will remain unattached.

e) Connect the red wire to the top right spade.

BR

OW

N

BLUE

E

BR

LU

OW

B

ED

R

R

ED

ED

R

N

ED

R

BL

U

R

ED

6.

When finished with steps a) through e) your final wire connection configuration should appear as above.

www.pro-team.com 866.888.2168

Install the switch into the handle bezel. Place the long

BLUE, BROWN, then RED wires between the screw bosses in that order (as shown). BROWN and BLUE wire loops must be positioned above the screw bosses on the handle bezel as shown.

(Continued on page 35)

34

Handle

HANDLE ASSEMBLY

(CONTINUED FROM PAGE 34)

7.

Switch must remain flat to the handle bezel when installed into handle body as shown.

8.

Press the switch into place in the handle bezel.

The II position should be closest to the front of the bezel.

A

B

35

9.

Lay the long red, brown and blue wires between the circular shoulders and gently place handle bezel into handle.

10.

Slide tab A into handle slot B and press firmly into place at C. Be sure all switch wires are routed between screw bosses to ensure that the wires do not get damaged. Insert screws into bezel (fig. 5).

fig. 5

C

www.pro-team.com 866.888.2168