advertisement
▼
Scroll to page 2
of
44
![Carbon Brushes. ProTeam 107251, 107252 | Manualzz Carbon Brushes. ProTeam 107251, 107252 | Manualzz](http://s1.manualzz.com/store/data/006276666_1-c764b108adce7026fcadbd709da21ee7-360x466.png)
Motor
REMOVING CARBON BRUSHES
1.
Disconnect wire from carbon brush.
2.
INSTALLING CARBON BRUSHES
Remove both locking connectors with small flat tip screwdriver. Press brass tab (inside bracket) down so it is flush with brush.
3.
Using pliers (or fingers), carefully grasp tab and remove carbon brush from bracket
1.
Insert carbon brush into bracket.
www.pro-team.com 866.888.2168
2.
Carefully bend brass tab slightly upward with small flat tip screwdriver.
3.
Re-connect wire. Replace locking tabs. Bend tabs downward.
24
advertisement
Related manuals
advertisement
Table of contents
- 3 Index
- 4 Disassembly
- 5 Index
- 6 Disassembly
- 7 Bag Lockout Switch Replacement
- 8 Hose Cap Collar Repair
- 9 Quick Release Clip Replacement
- 10 Bag Housing to Motor Housing Assembly
- 11 Index
- 12 Disassembly
- 16 Wand Guide
- 17 Wire Harness Replacement
- 25 Carbon Brushes
- 26 Index
- 27 Assembly
- 28 Power Nozzle to Body Assembly
- 29 Hose Sleeve Replacement
- 30 Pivot Bearing Replacement/Wheel Replacement
- 31 Detent Spring Replacement
- 32 Index
- 34 Assembly
- 37 Handle/New Power Cord & Strain Relief Replacement
- 39 Handle and Power Cord Installation
- 40 Impact Bumper Installation
- 41 Assembly
- 42 Clearing Hose and Wand Obstructions
- 40 www.pro-team.com