KMPi TFF System Instructions for Use

SYSTEM SETTINGS

KMPi

i.

Pump Mode Status Timeout Display – When Auxiliary Scales are connected and powered on, the user will be able to view the Pump Mode Status Timeout Display. The Timeout Display will show current weight information related to the current Pump Mode if the user highlights the double arrow button and does not touch the pump for seven seconds

(see Section 8.2 for

Timeout Display details).

Spectrum: C

Pf:

Pp:

Pr:

0.0 Psi

0.0 Psi

0.0 Psi

TMP: 0.0 Psi

Feed: 585 ml/min

D

F

Pump Mode Resume Icon

Diafiltration Pump Control Icon

Permeate Pump Control Icon

7.6.3. System Settings

a.

Pump Mode – Depending on user’s Auxiliary Components, user may select one of many Pump

Modes for KMPi to operate in that allow for manual, semi-automated, and automated processes

b.

Pressure Calibrate – Using a calibrated pressure source, the user can calibrate pressure transducer readings

Spectrum: CDDC

F:1.00

Pf:

Pp:

0.0 Psi

0.0 Psi

Pr: 0.0 Psi

2.00

TMP: 0.0 Psi

Conc

Feed: 585 ml/min

c.

Alarm and Stops – Safety pressure alarm and stops

d.

Tubing Calibrate – After running the tubing in the pump for ten minutes, the user may calibrate the tubing to ensure accurate fluid dispensing

e.

Aux Pumps – KMPi’s Aux Pump settings must be configured prior to using the Auxiliary Pumps to ensure the KMPi sends the correct commands to each pump

f.

Hardware Setup – Time, date, unit of measure, and some Pump Mode options may be set from the Hardware Setup menu

g.

Diagnostics – Diagnostics are for the factory use only, but may viewed by the user

14

KMPi TFF System • PRODUCT INFORMATION AND OPERATING INSTRUCTIONS