- Computers & electronics
- Audio & home theatre
- TV set-top boxes
- Satellite antennas
- TracVision
- M5, M7 & M7SK
- User's Guide
advertisement
![Displaying the Calculated Skew Angle. TracVision M5, M7 & M7SK | Manualzz Displaying the Calculated Skew Angle. TracVision M5, M7 & M7SK | Manualzz](http://s3.manualzz.com/store/data/022484965_1-acf0f57602f9892a052b3e9c41219b47-360x466.png)
32
TracVision M5/M7 User’s Guide
Chapter 3 - Settings
Displaying the Calculated Skew Angle
Use the flowchart in Figure 3-2 to display the average skew angle for
your selected satellites. If just one satellite is configured for tracking, that satellite’s skew angle is displayed.
IMPORTANT!
An accurate skew angle reading requires current latitude and longitude data. If necessary, be sure to update the latitude and
longitude data before proceeding (see “Updating Latitude and
Longitude Data” on page 31 for more information).
Figure 3-2 Displaying the Calculated Skew Angle
<Default Display>
Menu
Install Satellite?
Yes Next Return
Select Next until “Operations
Mode?” is displayed.
Operations Mode?
Yes Next Return
Get Antenna Status?
Yes Next Return
Get system errors?
Yes Next Return
Select Next until “Get skew angle?” is displayed.
Get skew angle?
Yes Next Return
Skew Angle
OK
##.#
advertisement
Related manuals
advertisement
Table of contents
- 9 Using this Manual
- 11 System Overview
- 14 Circular and Linear Versions
- 17 Receiving Satellite TV Signals
- 18 Turning the System On/Off
- 19 Changing Channels and Switching Between Satellites (Circular Versions)
- 26 Changing Channels and Switching Between Satellites (Linear Versions)
- 29 Receiver Requirements
- 31 Product Care
- 33 Updating Latitude and Longitude Data
- 34 Displaying the Calculated Skew Angle
- 35 Adjusting the Skew Angle (Linear Versions)
- 39 Setting Sleep Mode
- 40 Setting Instant On
- 41 Adjusting Display Brightness
- 42 DISH Network/ExpressVu Setup
- 48 DIRECTV Dual-Sat Mode Setup
- 49 Circular Custom Dual-Sat Setup
- 52 European Tri-Sat Mode Setup
- 54 Linear Dual-Sat Mode Setup
- 57 Selecting Automatic or Manual Satellite Switching
- 58 Resetting to Factory Default Settings
- 59 Restarting the TracVision System
- 61 Five Simple Checks
- 62 Troubleshooting Matrix
- 63 Causes and Remedies for Operational Issues
- 67 Technical Support
- 69 Manually Controlling the Antenna
- 70 Updating Satellite Frequency Data
- 72 Configuring Satellite Settings
- 73 Displaying Software Version Information
- 74 Displaying the Antenna Serial Number
- 76 European Position Grid
- 77 North American Position Grid
- 79 TracVision M5 Wiring Diagram for One or Two Receivers
- 80 TracVision M5 Wiring Diagram for Three or Four Receivers (Circular Versions Only)*
- 82 TracVision M7 Wiring Diagram for One or Two Receivers
- 83 TracVision M7 Wiring Diagram for Three or Four Receivers (Circular Versions Only)*
- 84 TracVision M7 Wiring Diagram for Three or Four Receivers (Linear Quad-output Versions Only)