5.5 Reset to factory defaults. Technicolor MediaConnect TG234

Cannot connect via WPS

If you have trouble connecting your wireless client via WPS, try one of the following:



The WPS session only lasts 2 minutes, make sure to press the WPS button on both devices within this time slot.



Move the devices closer to each other.



Wait until the WPS LEDs of the TG234 and other devices are off and then try again.



Configure manually.

For more information, see

“4.3 Connecting manually without WPS” on page 42

.

5 Support

DMS3-CTC-25-221 v1.0

49

5 Support

5.5 Reset to factory defaults

Introduction

If at some point you can no longer connect to the TG234 or you want to make a fresh install, it may be useful to perform a reset to factory defaults.

Warning

A reset to factory default settings deletes all configuration changes you made. Therefore, after the reset a reconfiguration of your TG234 may be needed.

Also your wireless connections will be lost. You have to set up your wireless connections after you reset your TG234.

To reset the TG234 via the Reset button

Proceed as follows:

1 Make sure the TG234 is turned on.

2 Push the Reset button for 7 seconds and then release it.

Reset

3 The TG234 restarts.

Your system administrator may have disabled the physical reset button of the TG234. In this case, a hardware reset to defaults is not possible.

DMS3-CTC-25-221 v1.0

50

TECHNICOLOR WORLDWIDE HEADQUARTERS

1-5 rue Jeanne d’Arc

92130 Issy les Moulineaux

France

www.technicolor.com

Copyright 2015 Technicolor. All rights reserved.

All tradenames referenced are service marks, trademarks, or registered trademarks of their respective companies. Specifications subject to change without notice.

DMS3-CTC-25-221 v1.0