advertisement
3200.ENv1_9310067.book Page 112 Thursday, September 18, 2003 8:42 AM
19 Hardware and enhancements
• HARDWARE
Connection ports and other tools
• Charger connector (1)
• Flashlight (2)
• Pop-Port™ connector for headsets and data cables (3)
• IR (infrared) port (4)
• Camera lens on the back cover of the phone (5)
2 3
4
5
1
Recharge the battery
Your phone is powered by a rechargeable battery. To charge the battery:
1
Plug the charger transformer in to a standard ac outlet.
2
Insert the charger output plug into the round connector at the bottom end of the phone.
After a few seconds, the battery indicator in the display starts to scroll from bottom to top. If the battery is completely flat, it may take a few minutes before the charging indicator appears on the display or any calls can be made.
You can use the phone while the charger is connected.
The battery provides up to 4 hours of talk time and up to 12 days of standby time.
Operation times are estimates and may vary depending on network conditions, charging and phone use.
112 Copyright © Nokia 2003
3200.ENv1_9310067.book Page 113 Thursday, September 18, 2003 8:42 AM
Hardware and enhancements
Cut-out covers
You can use cut-out covers to quickly change the look of your phone. The phone is supplied with some ready-to-use cut-out covers.
Warning: Before changing covers, ensure the phone is powered off and disconnected from the charger or any other device. Avoid touching electronic components while changing the covers. Always store and use the phone with the covers attached.
1
Remove the back cover as described in “Remove the back cover” on page 14.
2
To remove the front cover, gently pull the top of the front cover from the phone.
3
Remove the old back cut-out cover from the back cover.
4
Remove the keymat and the old front cut-out cover from the front cover.
5
Place the new front cut-out cover on the front cover, then replace the keymat.
Nokia 3200 User Guide
113
Copyright © Nokia 2003
advertisement