Setup for the Printer. Panasonic DA-PC700, All in One Printer DA-PC700

6.2

Setup for the Printer

This section describes the procedure to set the LPD port to Enable (factory setting: Enable).

The protocol used by the transport layer is TCP/IP.

When setting the port to Enable leads to insufficient memory, a message about the insufficient memory may be displayed on the control panel and the port status may be set to Disable automatically. If this happens, set the ports which are not in use to Disable and change the memory size.

6.2.1

Setting the LPD Port to Enable

Follow the procedure below to set the LPD port to Enable. Once the LPD port is enabled, the protocol and the IP address can be set. If necessary, set the subnet mask and the gateway address.

Procedure

Press the

Settings/Meter Check

button on the control panel and select

Tools

Mode

on the screen displayed.

Enter the access number of the system administrator and touch

Confirm.

The factory setting of the access number is "11111".

6

95

6.2 Setup for the Printer

Select

Print/Scan Mode Settings

.

Select

Port Settings

.

Select

LPD

.

7

96

Select

Port Status

and then touch

Change Settings

.

Although the default setting of Port Status for LPD Port is Enable, we display the Disable setting here for illustrating this procedure of activating the port.

6.2 Setup for the Printer

Select

Enable

.

Select

Save

.

Restart the machine for the new setting to take place.

Repeat Steps to .

Select

NetWork Settings

.

Select

TCP/IP: Subnet Mask

and then touch

Change Settings

.

6

97

6.2 Setup for the Printer

Enter the subnet mask using the numeric keypad.

To move to the next bit, touch

Enter/Next

.

When the input is completed, select

Save

.

Repeat Steps to and input

TCP/IP: Gateway Address

in the same way.

Select

Save

until the screen of Step appears.

Select

Exit Tools.

98