In General. Panasonic DA-PC700, All in One Printer DA-PC700

14.1

In General

11

13.12 System/Meter Settings

This section explains the precautions and limitations of using this printer in general.

When switching on/off power

• After you have turned off the power, wait at least two seconds before turning it on again. If not, it might lead to the breakdown of the hard disk and memory.

• Do not switch off the power during the following circumstances:

(1) When the Communicating indicator and the Job in Memory indicator are lighted up.

Reason:

• The jobs stored in the memory might be cancelled.

• As there is a possibility of the printer hard disk being accessed, the printer hard disk might not be usable after this.

(2) During the five-second interval after the message, "Ready to Copy" is displayed and the printer is set to online mode.

Reason:

• As there is a possibility of the printer hard disk being accessed, the printer hard disk might not be usable after this.

• When "Printing" is displayed immediately after switching on the printer even no data have been sent, press the

Job Status Stop

button on the control panel to display the Job Status Confirm screen. Next, select jobs with "Printing" displayed, followed by

Stop

. Then press the

Clear C

button.

When cancelling printing

When the printing is not allowed to end normally such as by cancelling printing, the command information sent from the host will not be reflected in the control panel.

When initialized hard disk

• When the hard disk is initialized, all the data registered in it will be erased.

When specifying multiple-copy printing instruction (sorting) for a document with more than 701 pages

The copies will be sorted to 700 pages each and then output.

When using the collate feature for sorting multiple copies of printing

Collate Settings

of the "Output Options" tab of the printer properties dialog box has been checked. However, when the collate feature in the print dialog box of applications like

Microsoft Word 7.0 is selected, the desired print result may not always be obtainable.

When this happens, uncheck the collate feature and print again.

198

14.1 In General

When using the finisher with the puncher attached

• Papers that have been punched or stapled are output to finisher tray 2.

• Do not remove any paper from finisher tray 2 when the printer is outputting paper to it.

• Once finisher tray 2 is full with paper, printing will stop.

When this happens, remove all paper from finisher 2. Printing will resume automatically.

14

199