On Using TCP/IP (LPD). Panasonic DA-PC700, All in One Printer DA-PC700

14.3

On Using TCP/IP (LPD)

Be aware of the following precautions and limitations when using the printer with the TCP/IP (lpd) protocol.

14.3.1

During Setup

Setting up at the printer

•

Be very careful in setting IP addresses which are controlled as an entire system. Consult your network administrator before defining any IP address.

•

Depending on the network environment used, it may be necessary to set up the subnet mask and gateway. Consult your network administrator to set up the necessary items.

•

If setting the port to

Enable

leads to insufficient memory, a message to that effect will be displayed on the control panel and the port status may be set to

Disable

automatically. When this happens, set the ports which are not in use to

Disable

, change the memory size, or install more memory.

•

Specify the size for the receive buffer memory as required by the environment. If the size of the receive buffer memory is smaller than the file data to be received, the data may not be received.

Setting up at the PC/workstation

•

Be very careful in setting up IP addresses which are controlled as an entire system. Consult your network administrator before defining any IP address.

•

Before setting any network (such as the IP address) to a host being used under Network

Information Service (NIS), consult the NIS administrator.

14.3.2

During Switching Power On/Off

Take note of the following when switching off the printer:

When LPD Spool is set to Memory (spool mode)

All the print data spooled to the printer memory, including print data which is being output, will be deleted. When the printer is switched on again, the print data will not be found.

However, if the printer is switched off immediately after the print data has been sent, the data may be stored on the PC. In this case, when it is switched on again, the stored print data will be printed first even if new print data has been specified.

When LPD Spool is set to Hard Disk (spool mode)

All the spooled print data, including print data which is being printed, will be saved. When the power is switched on again, the stored print data will be printed first even if new print data has been specified.

14

203