HDMI Input (video signal). Eizo FS2434

●

HDMI Input (video signal)

The screen size can be changed with the “Screen Size” function.

Auto

Setting

Full Screen

Enlarged

Letterbox

Normal *2

Function

The monitor automatically changes the screen size according to the aspect ratio *1 and resolution information from the external device. This can be set only for HDMI (SD Signal) input.

Displays an image in full screen. Images are distorted in some cases because the vertical rate is not equal to the horizontal rate.

Displays an image in full screen. In some cases, a blank horizontal or vertical border appears to equalize the vertical rate and the horizontal rate.

Displays Letterbox of 16 : 9 in full screen. Except for

Letterbox, the upper and lower parts of the projected image are cut. This can be set only for HDMI (SD

Signal) input.

The image is displayed without scaling the input signals.

*1 The aspect ratio information of letterbox cannot be identified automatically.

*2 When “Screen Size” is “Normal”, “Overscan” is fixed at “Off”.

Procedure

1. Press on the remote control.

Each time you press , the size changes.

Note

• When “Normal” is selected, the display input lag is 2 frames or less.

Screen Display

To set the screen ratio

In order to hide distortion or noise at the image’s edge, the display area of the input image can be changed so that peripheral images are not displayed.

On

Off

Setting Function

Displays an input image in the screen by trimming the vertical and horizontal parts of the image.

Displays most of the input image.

Procedure

1. Press on the remote control.

The “Screen Size” menu appears.

2. Select “Overscan” with .

3. Use or for adjustment.

4. Press to exit.

Attention

• When “Screen Size” is “Normal”, “Overscan” is fixed at “Off”.

Chapter 2 Adjusting Screens

25