Recommended Installation Procedure. ASL INTERCOM SMC02G

SMC02G/SMC02F/Variants - Product Manual

3.2 Recommended Installation Procedure

!

!

Please read and observe the “ Safety and Precautions ” section on page 55 of this manual.

1. Produce the zone identification label as follows. a. Download the template file from the “Data Downloads” page of Application Solutions website: www.asl-electronics.co.uk/downloads. b. Complete the zone text in the appropriate button positions.

Note that a microphone button can also be programmed to route DVAs, in which case a text describing the function would be more appropriate. c. Print the label out. d. Cut the strips for each column of buttons to size.

2. Prepare the SMC02 mounting location. a. If mounting the SMC02 on a desk, prepare the recess by cutting the desk according to the dimensions detailed in Figure 12 . b. If mounting the SMC02 in a 19” rack, ensure that a U4 aperture is available for installation of the unit.

3. Insert the zone identification label as follows. a. Remove the 11 off screws on the SMC02 front panel. b. Lift the front panel as shown in the following figure ( Figure 2 ).

Figure 2 SMC02 – Label Slot Positions

LABEL SLOT

BUTTONS 1-5

LABEL SLOT

BUTTONS 6-10

LABEL SLOT

BUTTONS 11-15

LABEL SLOT

BUTTONS 16-20 c. Insert the label into the slot as shown in the following figure ( Figure 3 ).

For each label position a slot is provided between the front panel and its plastic cover.

If required use a small screwdriver to carefully lift the plastic cover at the required slot position.

Issue: 02 complete, approved

Page 21 of 60

SMC02G/SMC02F/Variants - Product Manual

Figure 3 SMC02 – Inserting the Zone Identification Labels

LABEL

BUTTONS 1-5

!

• Do not use any sharp tools, as they can damage the front panel.

• Do not peel off the plastic cover. d. Re-fit the front panel back in place using the 11 off screws removed in step 3.a

.

4. Ensure that the power supply from the central equipment rack is turned off.

5. Plug the lead assembly (ASL SMCLEAD-5M or SMCLEAD-20M) into the circular connector at the bottom of the SMC02 back box.

6. Fix the SMC02 into its position. a. If mounting the SMC02 on a desk, fit the SMC02 into the recess, and then fix it using the M6 screws and washers provided. b. If mounting the SMC02 in a 19” rack, fix the unit into its position in the rack using the M6 screws and washers provided.

Refer to Figure 12 for mechanical dimensions and clearance required.

7. If installing a SMC02F or SMC02FS, fix the fist microphone clip to a suitable adjacent point.

8. Connect the flying lead assembly to a marshalling box (which is cabled to the central equipment rack or wall mount Intellevac ACU).

See connection details in Section “ 4 Connections ” (page 23 ).

9. Power the unit on from the central equipment rack.

10. Commission the microphone as described in Section “ 5 Commissioning the SMC02 ” (page 31 ).

Issue: 02 complete, approved

Page 22 of 60