DVA Play Mode. ASL INTERCOM SMC02G

SMC02G/SMC02F/Variants - Product Manual

5.6.3.3 DVA Play Mode

Menu: Configuration Æ System Æ Router Æ Inputs Æ Mic/Line Æ < I/P # nn – MIC/LINE nn >

Æ < Zoned Fire Microphone or Paging Microphone > Æ Buttons Æ < Button # nn >

Æ DVA Routing Æ Control Æ DVA-Full or DVA-Part

Possible values: ‘DVA-Full’, ‘DVA-Part’

System default configuration: ‘DVA-Full’

If the DVA is configured to ‘Play Once’, then this setting should be ‘DVA-Full’.

The DVA play mode is only relevant for routing DVAs.

The DVA assigned to a ‘DVA Routing’ button may be configured to cease playing when the route is terminated or reset (‘DVA-Part’), or play until its end (‘DVA-Full’).

5.6.3.4 Busy Indication Mode

Menu: Configuration Æ System Æ Router Æ Inputs Æ Mic/Line Æ < I/P # nn – MIC/LINE nn >

Possible values:

Æ < Zoned Fire Microphone or Paging Microphone > Æ Buttons Æ < Button # nn >

Æ DVA Routing Æ Control Æ Busy=On or Off

‘Busy=On’, ‘Busy=Off’

System default configuration: ‘Busy=On’

It is possible to configure whether or not the route associated with a ‘DVA Routing’ button should cause a busy indication on the LEDs associated with microphone zone select buttons. If for instance this routing were used for background music control, then the busy LEDs would not need to be lit. If another type of route were being made, then the busy LEDs would normally be lit.

5.6.4 All Call Button

Menu: Configuration Æ System Æ Router Æ Inputs Æ Mic/Line Æ < I/P # nn – MIC/LINE nn >

Æ < Zoned Fire or Paging Microphone > Æ Buttons Æ < Button # nn > Æ AllCall

The button function is ‘select all zones’. When the button is pressed, all outputs, which have been configured as being affected by any zone selection buttons on the microphone, are selected for broadcast from the microphone, i.e. the button press has the same effect as if all zone selection buttons on the microphone have been pressed. Pressing a zone selection button will remove the zones associated to this button from the selection. Any button may be configured as an All-Call button.

See button operation in Section “ 2.2.1 Live Announcements ” (page 9 ).

Issue: 02 complete, approved

Page 39 of 60