Configuring the Listen-in Button. ASL INTERCOM SMC02G

SMC02G/SMC02F/Variants - Product Manual

5.5 Configuring the Listen-in Button

Menu: Configuration Æ System Æ Router Æ Inputs Æ Mic/Line Æ < I/P # nn – MIC/LINE nn >

Æ < Zoned Fire or Paging Microphone > Æ Buttons Æ < Button # nn >

Æ Switches Æ Switch #4 Listen-in

‘Not-Conf’, ‘Listen-in’, or ‘Security’ (not used for SMC02) Possible values:

System default configuration: ‘Not-Conf’

See Listen-in button operation in Section “ 2.2.4 Listen-in Operation ” (page 17 ).

Program switch ‘4’ for ‘Listen-in’ in order to enable the listen-in function on the PA LISTEN button on the

SMC02 console.

5.6 Configuring the Microphone Buttons

Buttons on Paging Microphone or a Zoned Fire Microphone may be configured as either:

• Not-Conf

• MIC Routing

• DVA Routing (VAR4/VA12/VAR20 only)

!

‘DVA Routing’ is only available on Paging or Zoned Fire Microphones that are connected to

VAR4/VA12/VAR20’s Mic/Line inputs 1 or 2.

• All-Call

• Route Reset

• Play DVA (ACU only)

• Cancel All DVAs (ACU only)

Each of these configurations is described in the following sections.

Consult the system design documentation to find the configuration of each button on the SMC02.

Menu: Configuration Æ System Æ Router Æ Inputs Æ Mic/Line Æ < I/P # nn – MIC/LINE nn >

Æ < Zoned Fire Microphone or Paging Microphone > Æ Buttons Æ < Button # nn >

Æ Not-Conf

Any button that is not in use should be configured as unused, to prevent inadvertent operation.

Issue: 02 complete, approved

Page 36 of 60