Safety and Precautions. ASL INTERCOM SMC02G

SMC02G/SMC02F/Variants - Product Manual

Precautions

10.1 Environmental

The temperature and humidity ranges shown in the specifications for this product must not be exceeded.

This equipment must not be installed in an area that is subject to a corrosive atmosphere, excessive moisture or may allow water or other liquids to come into contact with the unit or its external connections.

In the close proximity of some radio frequency transmitters, the signal to noise ratio of this product may be reduced. If this occurs, ensure adequate system RF earthing or re-locate the equipment or signal cables.

10.2 ESD

This product contains static-sensitive devices.

Observe ESD precautions when working on the equipment with the cover removed.

10.4.1 Packing for Return for Repair

All electronics assemblies must be properly packed in ESD protective packing for transport, to prevent physical and ESD damage. Use of non-ESD protective packing for return for repair or service will automatically invalidate the warranty.

The filler material used for packing for return for repair must be antistatic or static dissipative, as this may come into contact with exposed connectors, wiring, or PCB assemblies. The use of non-conductive filler material may cause damage to the electronic assemblies reducing their operational life, or even destroying them, and it will automatically invalidate the warranty.

Advice on packing the product for return can be provided by Application Solutions Limited.

Always replace blown fuses in the supply to this equipment with the correct type and rating.

Ensure power supply cabling is adequately rated.

10.4 Unpacking and Handling

The equipment should be unpacked and inspected immediately on receipt. If damage has occurred please advise your carrier or supplier.

It is advisable to retain the original equipment packing in the event that the equipment ever needs returning for service.

Ensure that the name and address of the

Authorised Distributor from whom you purchased the unit is recorded on the “ Service and Warranty ” page of this manual for future reference.

This equipment contains electronic devices that are sensitive to electrostatic discharge. Please take precautions to avoid damage to the electronics by static electricity.

Issue: 02 complete, approved

Page 55 of 60