advertisement
11.3 Touch Control ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Password
Password of the user configured on the computer.
Entry
Default value max. 32 characters empty
[Connect]
Establish the network connection. If the connection has been set up correctly, then all of the input fields will become inactive and the label switches to [Disconnect] . The network connection can be disconnected with this.
11.3.4 TCP/IP settings
900 Touch Control: Edit ▶ TCP/IP settings
If you have connected your Touch Control to your network, then you have to define the network-relevant settings in this dialog. The Touch Control requires an IP address so that it is identifiable on the network. The Touch
Control can acquire the IP address either dynamically from a DHCP server or you can enter the address directly.
Get IP address automatically (DHCP) on | off (Default value: on )
If this parameter is activated, then the Touch Control will obtain its IP address directly from a DHCP server. In this case, the remaining parameters can no longer be edited.
IP address
IP address for the Touch Control. IP addresses are 32-bit numbers and are written as sequences of four decimals, each separated by a period, e.g.
"10.157.212.8".
Entry
Default value x.x.x.x
192.168.10.11
"x" is a decimal between 0 and 255.
Subnet mask
The net mask or subnet mask, together with the IP address, indicates to which network the device to be connected belongs. Subnet masks are 32bit numbers and are written as sequences of four decimals, each separated by a period.
Entry
Default value x.x.x.x
255.255.255.0
86 ￭￭￭￭￭￭￭￭ 900 Touch Control
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Default gateway
11 Device manager
IP address for the standard gateway. A gateway sets up connections to several networks. It is located in the same subnet as the device to be configured.
Entry
Default value x.x.x.x
192.168.10.10
MAC address
Unambiguous address of the network adaptor for identification within a network. This parameter cannot be edited.
NetBIOS name
Unambiguous designation of the device within the network. This parameter cannot be edited.
11.4 Metrohm control instruments
￭
￭
￭
￭
￭
The following Metrohm devices can be used as control instruments:
Titrandos
Sample Processors
846 Dosing Interface
867 pH Module
856 Conductivity Module
The following specifications apply for all of the control instruments mentioned above.
Additional device configurations for the Sample Processor are described in
a separate chapter (see chapter 11.5, page 92)
.
900 Touch Control
The dialog shows the control instrument with its measuring inputs, the
MSB connectors and connected peripheral devices (dosing device, stirrer,
￭￭￭￭￭￭￭￭ 87
advertisement
Key Features
- Dynamic equivalence point titration (DET)
- Monotonic equivalence point titration (MET)
- Endpoint titration (SET)
- Water determination according to Karl Fischer (KFT)
- Titration with constant maintenance of the measured value (STAT)
- Manual titration (MAT)
- Coulometric water content determination according to Karl Fischer (KFC)
- Bromine index determination (BRC)
- Intuitive touch-sensitive screen for easy operation
- Comprehensive user administration for secure data management