advertisement
11.4 Metrohm control instruments ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Remote Box). If the control instrument is not connected, then the properties dialog of the control instrument will be displayed directly
.
[Properties]
￭
￭
￭
￭
Open the properties dialog of the highlighted entry.
The following properties can be displayed and edited to a certain extent:
Properties of the control instrument
Properties of the measuring inputs
This dialog is available only for devices which have a built-in measuring input.
Properties of the MSB connectors
Properties of the peripheral devices on the MSB connector (see chapter
11.4.1 Properties – Control instrument
Instrument list: Control instrument ▶ Edit ▶ Properties
Device name
This designation is used for identification purposes when selecting control devices (command, manual control).
Entry 24 characters maximum
Comment
Entry 24 characters maximum
Program version
Program version of the instrument software.
Serial number
Shows the serial number of the device.
11.4.2 Properties – Measuring input
Instrument list: Control instrument ▶ Edit ▶ Measuring input
1/2 ▶ Properties
88 ￭￭￭￭￭￭￭￭ 900 Touch Control
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 11 Device manager
In this dialog, you define the type of temperature sensor you have connected to the selected measuring input.
ADC type
Type of analog-digital converter.
Serial number
Serial number of the measuring interface.
Thick film type
Type of the thick film.
Temperature sensor
Type
￭
￭
The instrument supports the use of two different temperature measurement techniques:
NTC (Negative Temperature Coefficient)
Pt1000 (Platinum resistance)
Select here the type that has been connected to the instrument. If an NTC sensor is used, then it is also necessary to enter two sensor characteristics.
These characteristics are listed in the specifications of the sensor.
Selection
Default value
Pt1000 | NTC
Pt1000
R (25 °C)
This parameter can only be edited with Type = NTC .
Nominal resistance of the NTC sensor at 25 °C.
900 Touch Control ￭￭￭￭￭￭￭￭ 89
advertisement
Key Features
- Dynamic equivalence point titration (DET)
- Monotonic equivalence point titration (MET)
- Endpoint titration (SET)
- Water determination according to Karl Fischer (KFT)
- Titration with constant maintenance of the measured value (STAT)
- Manual titration (MAT)
- Coulometric water content determination according to Karl Fischer (KFC)
- Bromine index determination (BRC)
- Intuitive touch-sensitive screen for easy operation
- Comprehensive user administration for secure data management