advertisement
15.1 Sample data ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
￭
￭
Sample identifications (see chapter 15.1.1, page 148)
List with sample identifications. If you must enter the sample identification before starting a determination, then you can select the entries contained in this list.
Sample assignments (see chapter 15.1.2, page 149)
You can assign a particular method to a sample identification.
Use sample identification list on | off (Default value: off )
Activate this parameter so that the sample identifications defined in the list will be displayed as selections.
Use sample assignment table on | off (Default value: off )
Activating/deactivating the use of the sample assignment table.
NOTICE
If this parameter is activated, the following will no longer be possible:
￭
￭
Carrying out determinations without their sample identification being defined in the sample assignment table.
Defining a method in the sample table. Previously defined methods will be ignored.
Assignment ident.
Identification which is used as assignment identification to load the correct method.
Selection
Default value
Identification 1 | Identification 2
Identification 1
Request assignment identification on | off (Default value: off )
If this parameter is activated, then the sample identification will be requested automatically at the start of a determination.
15.1.1 Sample identification list
Main dialog: System ▶ Templates ▶ Sample data ▶ Sample identification list
148 ￭￭￭￭￭￭￭￭ 900 Touch Control
advertisement
Key Features
- Dynamic equivalence point titration (DET)
- Monotonic equivalence point titration (MET)
- Endpoint titration (SET)
- Water determination according to Karl Fischer (KFT)
- Titration with constant maintenance of the measured value (STAT)
- Manual titration (MAT)
- Coulometric water content determination according to Karl Fischer (KFC)
- Bromine index determination (BRC)
- Intuitive touch-sensitive screen for easy operation
- Comprehensive user administration for secure data management