29.10.4 Control instrument. Metrohm 900 Touch Control

29.10 Calibration of sensors (CAL) ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭

29.10.4 Control instrument

The control instrument the determination is carried out with is selected under [Control device] . Control instruments are defined under System ▶ Device manager .

NOTICE

This button is only displayed when several control instruments have been configured.

Control device

Selection of the control instrument from the list of devices. Only those devices are displayed which are able to carry out the command. The control instruments do not have to be connected. This allows to transfer methods more easily from one system to another.

Selection Selection of configured control instruments

29.10.5 Sensor

The parameters for the sensor are edited under [Sensor] .

Measuring input

Selection of the measuring input the sensor is connected to. The selection is not dependent on whether the control device has one or two measuring interfaces.

Selection

Default value

1 | 2

1

Sensor

Selection of the sensor from the sensor list. The selection depends on the measuring mode. Sensors are defined under System ▶ Sensors . You can also enter a sensor name which is not contained in the sensor list. When a determination is started there is a check whether the sensor is contained in the sensor list.

Selection Selection of configured sensors

Electrode check on | off (Default value: off )

This parameter is available only for the command CAL pH .

For the following electrodes, an electrode check can be carried out:

￭ pH electrodes

400 ￭￭￭￭￭￭￭￭ 900 Touch Control