Preparing tea. Fakir CHAILA INOX

EN saving during this period is automatically performed by the device. Without water in the kettle or when the water is under the minimum level, do not turn the on/off button (3) on. On/off button (3) must be turned off when there is no water. In terms of safety, the device is protected with two thermostats and these fuses are activated when there is no water and restarts when water is added.

Preparing tea:

Open the power cord and plug wrapped around the power transmission base (5) of your device and plug into a grounded socket. When the device is not in use, keeping the on/ off button (3) in off mode will facilitate the continuous plugging of this unit in the kitchen.

According to the amount of the tea you wish to brew, fill the kettle (1) with water within maximum and minimum levels . Locate the kettle on the power transmission base (5).

Open the lid of the teapot and remove the tea strainer (7).

Put adequate amount of tea on the strainer and locate it into the teapot after washing it slightly with cold water. Turn the on/off button (3) and keep warm button (2) to on position. The red indicator led will flash and the water will start to get warmer. According to the amount of water added, the water will start to boil within 3-8 minutes and the keep warm button (2) will automatically pass to off position and reduce the heating power to keep the water in boiling condition in the minimum level and to provide energy saving. The indicator led will be green.

Brew the tea with boiling water and place the teapot on the kettle. When needed, add water into the kettle. If you add water, bring the keep warm button (2) to on position again.

Kettle:

You can use it for heating and boiling water when needed in the kitchen. In order to do this, fill the kettle with water like in tea preparation process, locate it on the power transmission base and through covering the kettle with the teapot or lid, bring the keep warm button (2) and on/off button (3) to on position. Like explained in tea preparation section, the device boils the water in a short time and passes to keep warm mode. If you add water, bring the keep warm button (2) to on position again.

Cleaning and maintenance of the device

1- When tea service or water heating process is over, you must bring the on/off button

(3) to upwards position and turn it off.

2- The tea strainer, glass and inox teapot can be washed by hand or in the dishwasher, however we recommend you to wash them by hand for a longer use. The water in the kettle is discharged and this part is wiped with a dry or damp cloth, never wash through immersing into water.

3- The lime in the water will accumulate on the kettle’s base within the time and form a brown layer by burning and drop the efficiency of the kettle. In this case, turn the button off after the water is boiled, then boil with a little amount of vinegar and maximum capacity of water and after waiting for a period, shake and remove the solved lime. You can repeat the process if the lime on the base is not cleaned. Do not forget to rinse well with water then.

19