Discrete output parameters. Schneider Electric Software PLC Application-Specific Functions, Micro/Junior/Pro, 4.5
Pubblicità
Pubblicità
Discrete application configuration
Discrete output parameters
At a Glance The discrete output modules contain parameters per channel or per group of consecutive channels.
Parameters
Module reference
No. of outputs
TSX DSZ 04T22 4
TSX DSZ 08R5
TSX DSZ 08T2
TSX DSZ 08T2K 8
TSX DSZ 32R5
TSX DSZ 32T2
TSX DMZ 16DTK 8 (outputs)
TSX DMZ 28AR
TSX DMZ 28DR 12 (outputs)
TSX DMZ 28DT
8
8
32
32
The table below shows the parameters available for each discrete output module.
12 (outputs)
12 (outputs)
TSX DMZ 28DTK 12 (outputs)
TSX DMZ 64DTK 32 (outputs)
TSX DPZ 10D2A 2 (outputs)
Associated task (1)
Mast
Mast
Mast
Mast
Mast
Mast
Mast
Mast
Mast
Mast
Mast
Mast
Mast
/ Fast / None
/ Fast / None
/ Fast / None
/ Fast / None
/ Fast / None
/ Fast / None
/ Fast / None
/ Fast / None
/ Fast / None
/ Fast / None
/ Fast / None
/ Fast / None
/ Fast / None
Reactivate
Programmed /
Automatic
-
Programmed /
Automatic
Programmed /
Automatic
-
Programmed /
Automatic
Programmed /
Automatic
-
-
Programmed /
Automatic
Programmed /
Automatic
Programmed /
Automatic
-
Fallback mode Supply fault monitoring
Fallback to 0/
Maintain state
Active / Inactive
Active / Inactive Fallback to 0/
Maintain state
Fallback to 0/
Maintain state
Fallback to 0/
Maintain state
Active
Active
/ Inactive
/ Inactive
Active / Inactive Fallback to 0/
Maintain state
Fallback to 0/
Maintain state
Fallback to 0/
Maintain state
Fallback to 0/
Maintain state
Active
Active
Active
/ Inactive
/ Inactive
/ Inactive
Active / Inactive Fallback to 0/
Maintain state
Fallback to 0/
Maintain state
Fallback to 0/
Maintain state
Fallback to 0/
Maintain state
-
Active
Active
Active
Active
/ Inactive
/ Inactive
/ Inactive
/ Inactive
Key:
(1) Group of 8 consecutive channels, except for the last group if this has less than eight channels.
78
TLX DS 37 PL7 xxE
Discrete application configuration
Note: l l
Parameters in bold correspond to the parameters configured by default.
When a group of channels is not assigned to a task None , the corresponding channels are not exchanged by the input/output system.
TLX DS 37 PL7 xxE
79
Scarica
Pubblicità