Analog debugging
Introduction to the Debugging function
General This debugging function can be accessed for each module from the channel parameters (See
Display of Channel Parameters, p. 237) display screen. This is
only possible if the PLC is in on-line.
The debug screen is displayed: l Either from the pull-down dialog box which is used to alternate access to the parameter Debugging and Configuration functions.
TSX 3722 [POSITION 00.2..10]
Configuration
Désignation : Processeur 3722
Debug
Cycle
Normal
Fast
Fallback mode on failure
Fallback to 0
Maintain value l Or from the View menu in the PL7 Micro software and the Debugging option.
The Debugging function is used to display in on-line mode, the parameters for each of the analog module channels, including the interface built-in to the PLC TSX 37-22.
This function is also used to access diagnostics for the module and selected channel when a fault is present.
254
TLX DS 37 PL7 xxE
