Configuration
Declaring the axis control modules
Introduction This operation involves declaring the axis control modules in the PLC configuration.
Adding a module To add an axis control module into the PLC configuration, proceed as follows:
Step
1
2
Action
Choose the rack in which the axis control module is to be placed.
In the rack, select and confirm the position in which the TSX CAY module will be placed. If the module takes up two positions (TSX CAY 41/42/33), the second empty slot where the module will be placed must be selected.
The following dialog box is used to add the module to the configuration:
Add module
Family:
Analog Module 1.5
Communication1.5
Counting 1.5
Remote BusX 1.0
Movement
Wheighing
1.5
1.5
Simulation
Discrete
1.0
1.5
Module:
TSX CAY 21
CAY 33
TSX CAY 41
TSX CAY 42
TSX CFY 11
TSX CFY 21
2 CHAN. AXIS CONT. MOD
MOD.CDE AXE 3
4 CHAN. AXIS CONT. MOD
4 CHAN. AXIS CONT. MOD
1 CH STEPPER MOTOR MOD.
2 CH STEPPER MOTOR MOD.
OK
Cancel
5
6
3
4
Select Movement from the Family field.
Select the module reference (TSX CAY) from the Module field.
Confirm with OK.
After confirmation, the module is declared in its position. This is framed and contains the module reference
0
1
0
0
2
6
P
S
Y
0
3
0
5
7
2
T
S
X
4
2
C
A
Y
3 4
74
TLX DS 57 PL7 xxE
Configuration
Deleting a module l l l
To delete a module from its position: click on the module to select it, press the <Del> key, and a dialog box is displayed,
Confirm deletion of the module.
Moving a module To move a module from one position to another: l l l l click on the module to select it, activate the Edit
→
Move module command, l Set the destination position.
You can also: select the module using the mouse, without releasing the left mouse button, drag the module to its destination (Drag and drop).
TLX DS 57 PL7 xxE
75
