Programming
Entering SMOVE function parameters
Introduction A movement command is programmed by an SMOVE function using the following syntax:
SMOVE %CHxy.i(N_Run,G9_,G,X,F,M)
The Details screen can be used to assist you with the entry of each parameter.
SMOVE function details screen
The SMOVE function details screen is as follows:
SMOVE
Channel address
N_Run 1 Cancel
Movement codes
Movement number
G9_ Cancel
G
F x
G01
G14
G09
G62
+
+
++
0.0
G11
G07
1 2 3
G10
G05
X Position increment
F 500 Cancel
Paramètres M
Z
Movement speed
Sorties TOR auxiliaires
Evt source Inchangées
Synchronous with
Consecutive with
AUX 0
OK Cancel
Entry fields (for SMOVE function parameters) as are follows:
G
X
F
M
Parameter
%CHxy.i
N_Run
G9_
Description
Channel address.
Movement number.
Movement type.
Instruction code.
Coordinate of target position.
Speed of moving part.
Event processing, auxiliary discrete output associated with channel.
TLX DS 57 PL7 xxE
115
