Installing the OAI Integration Server software. Mitel 8500

Configuring

UNIVERGE

UM8500 for the integration

After ensuring that the UNIVERGE UM8500 server is ready for the integration by completing all appropriate tasks in the Installation Guide, perform the following procedure to confirm that the integration is enabled.

To confirm the integration is enabled

1 Click Start > All Programs > UNIVERGE UM8500 > Edit Switch .

2 If prompted for logon credentials, type the administrator extension and password, then click OK .

On a new install the logon credentials are:

Extension = 99995

Password = 12345

3 Confirm that the settings match those in the following table.

Phone settings for OAI integrations with digital ports

Manufacturer

Model

Specific version or country

Integration method

NEC

NEAX2400 IMS

HDS R4 and later digital board with

OAI

OAI

4 If the settings are incorrect, select the correct settings and click Update

Voice Mail Now

.

To update the INI file

1 Using Windows Explorer on the UNIVERGE UM8500 server, go to the

CommServer\IntLib directory.

2 Use a text editor to open the corresponding configuration INI file noted in the previous procedure.

3 In the [Configuration] section, modify the NetIP1 value:

■

Replace the NetIPI with the exact IP address that the computer is using to access the same LAN as the phone system.

Example: NetIP1=172.16.19.191

.

■

The NetIP1 = the IP address of the computer where UM8500 is installed; the default value is set to "localhost" but it should be changed because it is possible for the server machine to have more than one network interfaces.

4 If using the OAI UCD - LAN MCI integration, under [Configuration], locate

UseInternalParser=no . Change this to

UseInternalParser=yes .

5 Click

File > Save

, and then close the configuration INI file.

NEC UNIVERGE SV8500

USING

OAI 273