Configuring UNIVERGE UM8500 for the integration. Mitel 8500

Programming the phone system

If you use programming options other than those described in the following procedure, the integration’s performance may be affected.

NOTE

Always use an antistatic wrist strap or grounding device when handling boards or other components. Static electricity can damage the components in phone system equipment.

To program the phone system

1 Select specific voice messaging system ports to be used for the integration, and the remaining ports to be used for the automated attendant, if appropriate.

2 On the phone system, activate the SMDI port.

3 In “System assignments,” set the following:

■

Program 10-2 = LED 4 should be turned on for the voice messaging system to turn off message waiting indication.

■

Program 10-3 = LED 8, 9, 11, 13, 14, and 20 should be turned on for correct spacing and digit length. LED 8 allows the phone system to pass caller ID information to the voice messaging system.

4 In Program 13-1, enter the lowest standard phone port connected to the voice messaging system.

5 Set Program 31 = LED 4, 5, 9, 15-18 should be turned on.

6 For Toshiba DK280 release 3 or higher and DK424 systems, assign all phones connected to voice mail to the lowest standard phone port connected to the voice messaging system.

NOTE

The PPTC connector is a special adapter that converts the sixconductor line cord to a DB 25 connection. The default pinouts from Toshiba will not work. Use the following pinouts so the packet data is able to transmit and receive all information correctly.

Modular to PPTC 25 Pinout

1 to 7

2 to 8

3 to 20

4 to 6

5 to 2

6 to 3

Short pins 4 and 5 on the PPTC connector

Modular to PPTC 9 Pinout

1 to 5

2 to 1

3 to 4

4 to 6

5 to 3

6 to 2

Short pins 7 and 8 on the PPTC connector

T

OSHIBA

CIX100/200/670, CTX 100/670,

AND

S

TRATA

DK

SERIES 331