PMC-5151 User Manual

ICP DAS PMC-5151 User Manual

6.9 Firmware Update

PMC-5151allows to update firmware via browser, after the update is completed; the PMC-5151 doesn’t require to reboot. Please follow the steps below: i. Please contact ICP DAS service to obtain the latest version of the

PMC-5151 firmware file. ii. Go to “System Setting” page, under the “Firmware Update Setting”, click on “Browse”.

Figure6-32 : Firmware Update(1)

68

ICP DAS PMC-5151 User Manual iii. Browse through to select the new firmware file and click “Open”.

Figure6-33 : Firmware Update(2)

iv. Click “Update” to update the firmware.

Figure6-34 : Firmware Update(3)

v. Click “OK” to start the firmware update, to cancel the firmware update, click “Cancel”.

Figure6-35 : Firmware Update(4)

69

ICP DAS PMC-5151 User Manual vi. Updating the firmware

Please note: when the firmware update process is started, please DO

NOT close the update window or perform any system modification, or may result in unexpected failures.

Figure6-36 : Firmware Update(5)

vii. Click “OK” to complete the update process. After the update is completed, please clear the cache and cookies on your browser . If the update process is failed, please perform the update again.

Figure6-37 : Firmware Update(6)

70