Connecting the telecommunications system . AGFEO AC 14 WebPhonie

Wall mounting ¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢

- Mark two vertical drill holes 125 mm apart on the wall.

- When marking the drill holes, make sure that there are no concealed lines at these points (gas, water pipes, electric cables or similar).

- Drill the two holes.

- Mark two vertical drill holes 125 mm apart on the wall.

- When marking the drill holes, make sure that there are no concealed lines at these points (gas, water pipes, electric cables or similar).

- Drill the two holes.

- Hammer in the plugs flush with the wall.

- Screw in the two screws leaving the head protruding by about 4 mm.

- Hang the telecommunications system on the screws and pull it down on the wall until it snaps into place.

S

Ready to start in seconds ¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢

- Plug the Western plug of the power pack into the socket marked "Power" until it snaps in audibly

- Plug one of the Western plugs of the ISDN connecting cable into the socket marked "S0" until it snaps in audibly

- Plug the other Western plug of the ISDN connecting cable into the NTBA (NT) or an installed ISDN socket

- Plug the Western plugs of your terminal into the

Western sockets of the telecommunications system

In the

as-delivered state

, the connections 1 and 2 are set to telephone, connection 3 to answering machine and connection 4 to combiport, e.g. for fax.

- Plug the power pack into a 230 V socket. The green LED lights up.

- You can now use the phone. After lifting the handset you will hear the external dialling tone and can call any external subscriber.

- The connections 11, 12 and 13 ring when one of your phone numbers (MSN) is called.

To enter your multiple subscriber numbers (MSN’s), change the ringing assignment and set other functions, please read the chapter "Programming".

Quick entry of multiple subscriber numbers ¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢

You can enter multiple subscriber numbers (MSN’s) under which you can be reached in the telecommunications system uncomplicatedly and quickly. Enter the MSN with this function at every connection and the corresponding terminal is entered in the ringing assignment for this MSN.

Example: Enter your phone number (345678) at connections 1, 2 and 3. At connection 4 the number of your fax (345677). Callers then reach your telephones and answering machine when they call 345678. The fax is reached under 345677.

See the “Programming Instructions” for further information.

Start programming mode: h

*PRO

PRO

(system -PIN) q

ª h * M S N S M z # q

Lift handset

MSN

quick

s

ave

M

SN-

ID

Exit programming mode: h

*END q

ª

END

Set up

Enter multiple subscriber number (MSN)

ª

Acknowledgement tone

Replace handset

S - 3