ADDING MARGINS (Margin Shift). Sharp MX-2700G, MX-3500N, MX-3501N, MX2700N, MX3501N, MX3500N, MX-4501N, MX-2700N Guide, MX-2300N, MX2300N

ADDING MARGINS (Margin Shift)

This function is used to shift the copy image right, left or down to adjust the margin.

This is convenient when you wish to bind the copies with a string or in a binder.

Shifting the image to the right so the copies can be bound at the left edge with a string

Not using margin shift Using margin shift

1

Margin shift positions

Left edge

1

1

The punch holes cut off part of the image

1

The image is shifted to the right to allow space for the string holes so the image is not cut off.

Top edge

Right edge

Place the original.

Place the original face up in the document feeder tray, or face down on the document glass.

1

2

Ready to scan for copy.

Full Colour

Colour Mode

Job Detail

Settings

Auto

Exposure

100%

Copy Ratio

1.

2.

3.

4.

A4

A4R

B4

A3

Original A4

Plain

A4

2-Sided Copy

Output

0

Special Modes

File

Quick File

Touch the [Special Modes] key.

3

Special Modes

Margin Shift

Pamphlet Copy

Erase

Job

Build

Dual Page

Copy

Tandem

Copy

OK

1/4

Touch the [Margin Shift] key.

59

4

(1)

Special Modes

Margin Shift

Right Left Down

(2) (3)

OK

Cancel

Side 1

10 (0 20) mm

OK

Side 2

10 (0 20) mm

Set the margin shift.

(1) Touch the margin shift position.

Select one of the three positions.

(2) Set the amount of the margin shift with

.

0 mm to 20 mm (0" to 1") can be entered.

(3) Touch the [OK] key.

You will return to the base screen of copy mode.

5 or

To cancel scanning of the original and copying...

Press the [STOP] key ( ).

(

Press the [COLOUR START] key

) or the [BLACK & WHITE

START] key ( ).

Copying will begin.

• If the originals were placed in the document feeder tray, the originals are copied.

• If you are using the document glass, copy each page one page at a time. If you are using the sort function or other function that requires all originals to be scanned before the copies are printed, you must use the same [START] key that you used to scan the first original to scan each of the remaining originals.

Rotation copy cannot be used in combination with margin shift.

To cancel the margin shift setting...

Touch the [Cancel] key in the screen of step 4.

System Settings (Administrator): Initial Margin Shift Setting

The default margin shift setting can be set from 0 mm to 20 mm (0" to 1"). The factory default setting is 10 mm ("1/2")".

60