Enhancing Photos. Canon Studio Solution

Using: Photo Library

 Set Tilt Angle: enter a number between 0 and 360 and select to rotate clockwise or counter-clockwise.

You can also orient photos by selecting any number of photos and right-clicking on them. Select Orient Photo, which contains all the previous options.

Enhancing Photos

To enhance a photo, select any number of photos and select Enhance from above the photo viewer. The Photo Workshop will open with these photos. You can also doubleclick a photo to enter the Photo Workshop and edit any photos from the event. Click

here for information on using the Photo Workshop.

Previewing Photos

To preview the event photos full-screen, select a photo and select Preview from above the photo viewer. The software will switch to Presentation Mode, where you can run

slideshows, play music, and view the photo with different frames. Click here for detailed

options during full-screen Presentation Mode.

Publishing Photos

To publish a photo:

1. Do not turn off the software while publishing.

2. Select any number of photos you want to publish.

3. Select Publish, located above the photo viewer.

4. Select Publish Selected.

5. The status bar at the bottom left of the software will turn blue and show a % of publishing.

6. When a photo is published, you will see a prompt and all published photos will show a P in the upper-left hand corner.

Un-Publishing Photos

To remove photos from your online storefront:

1. Select any number of photos you want to unpublish.

2. Select Publish, located above the photo viewer.

133