advertisement
80 Mounting
Pos: 74. 19 /Se rie 7 50 (WAGO I/ O SYSTEM)/ Mon tier en/De mon tier en/I/ O-M odul einf ügen (n eut rales 3D) @ 35\ mod _15 613 820 372 53_ 21.d ocx @ 548 869 @ 3 @ 1
5.6.3 Inserting the I/O Module
WAGO I/O System 750
750-890 Controller Modbus TCP; G4; 2ETH; SD
1. Position the I/O module in such a way that the groove and spring are connected to the preceding and following components.
Figure 32: Inserting I/O Module (Example)
2. Press the I/O module into the assembly until the I/O module snaps into the carrier rail.
Figure 33: Snap the I/O Module into Place (Example)
3. Check that the I/O module is seated securely on the carrier rail and in the assembly. The I/O module must not be inserted crooked or askew.
Once the I/O module has snapped into place, the electrical connections for the data contacts and power contacts (if any) to the head station or to the preceding and, if applicable, following I/O module are established.
Manual
Version 1.2.2
advertisement
Key Features
- High performance and large memory
- Integrated PLC functionality
- Support for various communication protocols
- Wide range of connection possibilities
- Suitable for complex automation tasks
- Use in various industrial environments