CHANGE PASSWORD. Xerox 6030, 8830, 8825, 721P, 8825 DDS, 8850 DS, 6050, 8850, 8830 DDS, 510

CHANGE PASSWORD

The CHANGE PASSWORD option of the SYSTEM ADMINISTRATION menu allows the system administrator to change the system administration password.

The default system administration password on all newly delivered machines is 0 (zero). The system administrator is required to change the password after the initial log in. Immediately following the log in, the

CHANGE PASSWORD screen is displayed. The password must be changed at that time.

If the existing password has been lost, call for service. The customer service engineer will reset the password to the default value of 0. The system administrator should then change the password to a different value.

NOTE: Changing the system administrator password on the Scan

System Control Panel also changes the system administrator password for the Printer. These two passwords always have the same value.

To change the system administration password: the key. the menu. See "Entering the system administration password" in this section. the key until CHANGE PASSWORD is highlighted. the key to select CHANGE PASSWORD. The

CHANGE PASSWORD screen is displayed.

CHANGE PASSWORD

ENTER OLD PASSWORD:

Change Password Screen

5. Use the numeric keypad to enter the old password. the key to confirm the old password. The CHANGE

PASSWORD screen will instruct you to enter the new password.

CHANGE PASSWORD

ENTER NEW PASSWORD:

Change Password Screen

7. Use the numeric keypad to enter the new password. The password will display as asterisks.

XEROX WIDE FORMAT COPY SYSTEM Main Menu

•

117