Cleaning the Calibration Strip. Xerox 6030, 8830, 8825, 721P, 8825 DDS, 8850 DS, 6050, 8850, 8830 DDS, 510

Cleaning the Calibration Strip

Perform the following steps monthly: the key, then scroll to the Diagnostic and press the

Enter

key.

•

Scroll to CLEAN CAL ZONE and press the

Enter

key.

•

Press the

Enter

key to select CLEANING POSITION.

NOTE: The Top Cover must be closed while running this test.

2. Raise the Top Cover.

3. Inspect the Calibration Strip.

4. Place a small amount of platen glass cleaning fluid (Xerox

43P81) on a clean, lint-free towel (600S4372) and clean the

Calibration Strip.

5. Lower the Top Cover.

6. Press

Enter

key to select HOME POSITION. the key to exit the CLEAN CAL ZONE. the key to return to the READY screen. The

Calibration Strip automatically returns to its home position.

XEROX WIDE FORMAT COPY SYSTEM Cleaning and maintenance - Scan System

•

145