OPERATION. EKOM DK50 2V, DK50 Plus Mobile, DK50 2V/M MOBILE, DK50 2V S, DK50 PLUS

OPERATION

OPERATION

THE EQUIPMENT MAY ONLY BE OPERATED BY THE TRAINED STAFF!

Risk of electric shock

In case of any danger, disconnect the compressor from the mains (pull out the mains plug).

Risk of burn or fire.

During compressor operation, the pump parts may heat to temperatures dangerous for contact with persons or materials.

Warning – compressor is controlled automatically.

Automatic start-up. When pressure in the pressure tank drops to switch-on pressure, the compressor automatically switches on. The compressor automatically switches off, when pressure in the air tank reaches the switch-off pressure.

Hazard of damage to pneumatic components.

Working pressures of the pressure switch set by the manufacturer must not be changed. If the compressor operates at higher working pressure than the switchon pressure, it means that the air consumption is too high (see Chapter

Malfunctions)

Hazard of damage to dryer.

When the dryer is operated at ambient temperature that is higher than maximum operating temperature stated in Technical data, the dryer can be damaged .

Prior to operation it is necessary to connect the housing using output transition piece for compressed air via internal thread G 1/4“. Disconnect the connected device only after the reduction of pressure in the pneumatic system to zero!

Required drying performance can only be achieved when the defined operating conditions are followed.

Drying performance decreases and the achieved dew point drops if the dryer is operated at any pressure below the minimum working pressure.

During longer operation of the compressor, the temperature in the surrounding of the compressor increases above 40 °C and the cooling fan switches on automatically. After cooling the space below 32 °C, the fan switches off.

NP-DK50 PLUS, 2V-MOBILE-A-4_12-2019-MD 26 12/2019